close
close

How To Reset Oil Light On Honda Accord 2010

How To Reset Oil Light On Honda Accord 2010

How To Reset Oil Light On Honda Accord 2010. The engine oil life indicator and the maintenance code (s) will blink. Turn the ignition to run (one position before starting engine).

How To Reset Oil Light On Honda Accord 2010How To Reset Oil Light On Honda Accord 2010
Reset Oil Light Honda Accord 2005 Shelly Lighting from shellysavonlea.net

If you’re not sure whether your accord has synthetic or conventional oil, you can check your latest oil change sticker. Turn the ignition to position “ on” without starting the engine. Holding the button down will reset the oil life indicator after about 10 seconds.

Press The Reset Button Located On Either The Steering Wheel Or As A Knob On Your Dash.

First, switch your ignition to the run position, which is one click before starting the engine. The engine oil life indicator and the maintenance code(s) will blink. How to reset oil service light honda accord.

must GO  B12 Honda Service Code Odyssey

Do Not Start The Vehicle.

The engine oil indicator will start blinking. Press the select/reset button for more than 10 seconds. To reset a 2011 honda accord oil light, follow these simple steps:

According To Honda, Though, You Can Use Synthetic Or Conventional Oil In Your Accord—Just Make Sure To Get The Oil Changed Regularly.

First, press and hold the “select/reset” button on the instrument panel, then switch the ignition to on while still holding the button. Press the trip button until the oil life shows at the bottom of the instrument cluster. The engine oil life should now reset.

Press The Select/Reset Knob For More Than 5 Seconds.

Press and hold selreset for good 10 seconds and then release the stem. It’s on the lower right side. Get a repair manual for your car:

Depending On The Model, Scroll Through Or Press The Knob Over And Over Until You See “ Engine Oil Life ”.

While the oil life is flashing, release the trip button, then push and hold again u ntil the oil life is reset to 100%. Turn the ignition to the “ on ” position. Press the select/reset button for more than 10 seconds.